nitin.blackhat
Newbie level 2
Hello all,
I am anewbie, with Eagle Cadsoft using the Free version, as I am designing the single sided/single layer PCB
my Schematic is ready, however, I have ULN2003 with relays which require +12v to drive the relay coils.
and also the ATMega8 which requires +5V as VCC
now how can i have both VCC within eagle??
any help?
TIA.
I am anewbie, with Eagle Cadsoft using the Free version, as I am designing the single sided/single layer PCB
my Schematic is ready, however, I have ULN2003 with relays which require +12v to drive the relay coils.
and also the ATMega8 which requires +5V as VCC
now how can i have both VCC within eagle??
any help?
TIA.