Radike
Member level 3
Hi,
I am new to AWR Microwave office software. I have some measured two port s-parameter data files. One file is for a capacitor. I need to include these files in my circuit and simulate using AXIEM or ACE.
I imported the data file and used the subcircuit to include it in the schematic. But I need to inlcude the pad dimension for this subcircuit so that I can get a propper layout. Is it possible to know how to do this?
I connected some passive transmission lines for this subcircuit and simulated in the schematic. It actually gave the correct results. However, when I try to use AXIEM or ACE I get wrong results.
Can somebody help regarding these issues?
Thanks!!
I am new to AWR Microwave office software. I have some measured two port s-parameter data files. One file is for a capacitor. I need to include these files in my circuit and simulate using AXIEM or ACE.
I imported the data file and used the subcircuit to include it in the schematic. But I need to inlcude the pad dimension for this subcircuit so that I can get a propper layout. Is it possible to know how to do this?
I connected some passive transmission lines for this subcircuit and simulated in the schematic. It actually gave the correct results. However, when I try to use AXIEM or ACE I get wrong results.
Can somebody help regarding these issues?
Thanks!!