Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to measure certain position with Allegro

Status
Not open for further replies.
T

tw_ht

Newbie level 1
Joined
Feb 26, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Hi, all
We can easily grab some points and measure the space between them. But how can we confirm the point we grabbed is the specific position we want, like the center point of the component.

Thanks in advance
 

normally mesurement is grid based (using Show measure tool).But if you select segments,lines or pins etc tool automatically picks the center point and picked co-ordinates are displayed in a new window .doing some mathematics with these coordinate you can confirm whether you picked the right location.
 

I think it can measure like this

1. Set the grid size is too low.

2. Form the find tab enable the shape check box only.

3. pick the mesurment first point and second point.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top