Itaniumfreak
Newbie level 3
Hi friends,
How are you?
I'm new here.
Please excuse me, I'm so directly.
I have a problem, therefore, beg you to help me.
I have expanded an electric Power steering (EPS) UNIT from a VW passat. I have disassembled this Unit to
get the 12 volts AC induction motor.
Now I want to build a frequency converter for it.
I think I have the necessary components to:
3x FUJI 2MBI300S-120 400A IGBT
10x IR2110 IGBT / MOSFET driver
1x battery
1x ATmega 32
and the components required for operation
I program exclusively with the c-compiler of CodeVisionAVR.
But my knowledge of programming are not sufficient to write a program. So I turn to you.
Can anyone of you help me to a write program for the ATmega32
microcontroller?
I want to adjust the frequency and the phase current via two separate
Potentiometer.
I would be obliged to you for your help very much to thank
best regards
Peter
Please excuse me for my bad english
How are you?
I'm new here.
Please excuse me, I'm so directly.
I have a problem, therefore, beg you to help me.
I have expanded an electric Power steering (EPS) UNIT from a VW passat. I have disassembled this Unit to
get the 12 volts AC induction motor.
Now I want to build a frequency converter for it.
I think I have the necessary components to:
3x FUJI 2MBI300S-120 400A IGBT
10x IR2110 IGBT / MOSFET driver
1x battery
1x ATmega 32
and the components required for operation
I program exclusively with the c-compiler of CodeVisionAVR.
But my knowledge of programming are not sufficient to write a program. So I turn to you.
Can anyone of you help me to a write program for the ATmega32
microcontroller?
I want to adjust the frequency and the phase current via two separate
Potentiometer.
I would be obliged to you for your help very much to thank
best regards
Peter
Please excuse me for my bad english