Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Not necessarily. JEDEC just specifies footprint, command set, etc.
But I mean the kind to access the memory contents. For read access this is the same as for SRAM. You simply specify an address at the address bus and the corresponding contents is provided at the databus.
So this flash can be connected to an microcontroller and the program runs directly from it. This is not possible with a NAND flash.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
