Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Some questions about measure spiral inductor on wafer

Status
Not open for further replies.

yorkyong

Junior Member level 3
Joined
Jun 20, 2003
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
255
GP-------------GP
SP-----@------SP
GP-------------GP

GP: Ground Pad
SP: Signal Pad
@: spiral inductor

The other questions are:
1. Do I need to connect two ground pads under the signal pad on each side?
2. Do I need to draw "open" "short" "through" and "load" for calibration?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top