gres
Full Member level 4
Many companies has special tools that allow conversion between IDE and USB. Thanks to that you can easily plug an IDE device to USB, but you still need to have own schematic . Below you can find list of tools for that:
IC’s
Cypress there are also a lot of design files.
Aliusa with a New USB2IDE devilce called ALI m5621
www.aliusa.com
Texas instruments **broken link removed** all of them has some IC’s
Prolific high speed usb and ieee1394 to IDE controller - PL-3507
**broken link removed**
Phillips isp1581 with easy interface that create IDE from USB. broken link removed
NEC uPD720121
**broken link removed**
Schematics:
Check those examples of some schematics:
ATA / IDE interface for cd rom or hard drive : **broken link removed**
http://www.translation.langenberg.com/):
**broken link removed**
**broken link removed**
USB controllers: **broken link removed**
Forum where you can find usb informations
www.usb.org,
http://www.usbdeveloper.com/
Power supply
Switch mode that is controlled by Maxim MAX1626 step down DC-DC controller is integrated with the main bard. This regulator is a hign efficienc. Power P-channel FET with 50 uH inductance axial allow to get 2 Amps current at output. This current is enough for 2 ½” disk. Input consist protection against inverted polarity, surges and spikes. It consist LP2980 3.3V regulator that supply the VS1001 and the 3.3V 74LVC245
Any ties of making IDE to USB interface are wrong
IC’s
Cypress there are also a lot of design files.
Aliusa with a New USB2IDE devilce called ALI m5621
www.aliusa.com
Texas instruments **broken link removed** all of them has some IC’s
Prolific high speed usb and ieee1394 to IDE controller - PL-3507
**broken link removed**
Phillips isp1581 with easy interface that create IDE from USB. broken link removed
NEC uPD720121
**broken link removed**
Schematics:
Check those examples of some schematics:
ATA / IDE interface for cd rom or hard drive : **broken link removed**
http://www.translation.langenberg.com/):
**broken link removed**
**broken link removed**
USB controllers: **broken link removed**
Forum where you can find usb informations
www.usb.org,
http://www.usbdeveloper.com/
Power supply
Switch mode that is controlled by Maxim MAX1626 step down DC-DC controller is integrated with the main bard. This regulator is a hign efficienc. Power P-channel FET with 50 uH inductance axial allow to get 2 Amps current at output. This current is enough for 2 ½” disk. Input consist protection against inverted polarity, surges and spikes. It consist LP2980 3.3V regulator that supply the VS1001 and the 3.3V 74LVC245
Any ties of making IDE to USB interface are wrong
Last edited by a moderator: