Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

L298N control dc motor in proteus

Status
Not open for further replies.
R

rocha_rm

Newbie level 1
Joined
May 7, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,286
I am newbie here in the forum and have an issue with the control of an engine bridge H (L298N). My problem is that the motor walks not in any sense. After activating the enable (pin11) and one switch (pin10 or pin11) dc motor was supposed to go in one direction, but he remains still. You know you tell me where this error

**broken link removed**
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top