Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Please follow me:
1) Create an 2D-rectangular object in any where that you want to place resistor, exactlly such as a CHIP resistor .
2) In boundary assignment menu, choose Lumped resistor and assign your object to this, in this way you must specify your resistor value (100 ohm).
3) You must define a line form Top of object to Bottom as current line.
Need some help about resistors in HFSS. i want to use Flange type resistors in my power divider so how should go with that & how the connection between resistors & impedance lines built up in hfss???
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.