Terp
Newbie level 3
- Joined
- May 3, 2010
- Messages
- 3
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- Oakland, CA
- Activity points
- 1,310
Hi All,
I posted this question yesterday, but it looks like it got lost somewhere. So, here it is again...
I simulated my voltage comparator schematic without glitches, got the layout done, and got it to pass the DRC checks, successfully extracted (I think...) the layout. But, when I run LVS, it terminates, displaying on the screen : "..... LVS Failed."
I checked my output log file, and found
"........ AEL's Message: Missing CDF Parameter" under schematic netlisting for all of my MOSFETs. So, then, I went ahead and made sure that my lambda was specified under CDF page, and re-ran the schematic simulation, which turned up no errors. But the LVS still fails, and the output log file still displays that message.
I would appreciate any help/suggestions on what my debugging steps should be.
Thanks, and best regards!
Added after 49 minutes:
An Update:
I just got the LVS run to succeed, and my netlists match as well.
I posted this question yesterday, but it looks like it got lost somewhere. So, here it is again...
I simulated my voltage comparator schematic without glitches, got the layout done, and got it to pass the DRC checks, successfully extracted (I think...) the layout. But, when I run LVS, it terminates, displaying on the screen : "..... LVS Failed."
I checked my output log file, and found
"........ AEL's Message: Missing CDF Parameter" under schematic netlisting for all of my MOSFETs. So, then, I went ahead and made sure that my lambda was specified under CDF page, and re-ran the schematic simulation, which turned up no errors. But the LVS still fails, and the output log file still displays that message.
I would appreciate any help/suggestions on what my debugging steps should be.
Thanks, and best regards!
Added after 49 minutes:
An Update:
I just got the LVS run to succeed, and my netlists match as well.