Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

gummel poon model vs HICUM model

Status
Not open for further replies.
E

EEsj

Junior Member level 1
Joined
Aug 3, 2008
Messages
19
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,393
Hi

I am looking at a modeling design manual for a SiGe process and am sort of unsure of which HBT model to use.


When i run PVT monte carlo the simulator defaults to gummel poon model for the simulation, but the manual states that HICUM may be more accurate.

data shown in the manual show good agreement between both models and measured data so I am wondering in the end which model will give the best accuracy when the device is fabd.

any opinions?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top