Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Sourcing ACS758 hall effect current sensor

Status
Not open for further replies.

stube40

Member level 3
Joined
Feb 10, 2010
Messages
55
Helped
4
Reputation
8
Reaction score
4
Trophy points
1,288
Location
Queensland, Australia
Activity points
1,825
Any good suggestions where I can get hold of the Allegro ACS758 hall effect current sensor in low quantities with short lead times? I'm in Australia, but shipping costs aren't important.

I've already tried RS, Farnell and Digikey - all out of stock and long delays before new stock.
 

Try X-ON Electronic Services; they display 10-in-stock:
**broken link removed**

Rgds.
IanP
:|
 

IanP said:
Try X-ON Electronic Services; they display 10-in-stock:
**broken link removed**

Rgds.
IanP
:|

Unfortunately not quite the variant I was after - I need the ACS758LCB-100B-PFF-T

However, the bizarrest this is - the link you provided worked initially, now everytime I click it the X-ON site comes up with "0 search results". It's almost as if they updated the site to remove the ACS758 as I was using it. However, it's more likely that my browser is playing games - I will try a lucky re-boot and see how it goes.

Thanks for the X-ON site though - it's a gem by the looks of it.
 

hai,


presently am designing power monitoring system project in that am using ACS 756 IC. it gives sinusoidal output corresponding to the load .
when i trying to interface it with ADC of my controller, i try to catch the peak voltage of ADC for corresponding loads.
but the out put is not stable .could u suggest me some solution how measure the current from ACS 756?thanks for your support.


regards,
karthikeyan
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top