Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help,about the momentum in ADS

Status
Not open for further replies.
Y

ybhphoenix

Newbie level 3
Joined
Mar 14, 2010
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,309
help. I want to use command line in the linux shell to call momentum simulation (S-parameters).
I want to import the GDSII file into the ADS,use special substrate file, add the port (at the needed position)to the dsn file, then do the momentum simulation. I need do all the things before in the command line(shell).
I know it may relate with the "momEngine" "hpeesofemx" "momServer" "rfdeMomWrapper"(/ads/bin/), I can see the only demo in the ADS "momAutoTest.ksh".

Thank u so much for the reply~
 

Read on command line AEL macro recording.
start the recording,
then carry all the actions listed above.
stop the recording and copy, save it.

do the final trimming for the commands that u may interest and run this script.
 

    Y

    ybhphoenix

    Points: 2
    Helpful Answer Positive Rating
kspalla said:
Read on command line AEL macro recording.
start the recording,
then carry all the actions listed above.
stop the recording and copy, save it.

do the final trimming for the commands that u may interest and run this script.
Click to expand...


thank u very much, and it really help! now i know how to import the gdsii files and add port.

But I still don't know :
1.how to run the momentum simulation in the linux shell. the macro recorder doesn't record this command.
2.how to make the ael script run automatically when starting the ADS
 

yes, i observed the same. give me some more time.
I do not have Linux but the script should be same I guess.

Added after 1 hours 54 minutes:

Here is the solution.
let me know if you can open below link

**broken link removed**
 

    Y

    ybhphoenix

    Points: 2
    Helpful Answer Positive Rating
please can you help me because I could not open the following link:

**broken link removed**[/QUOTE]

I need to know how to launch a momentum simulation from an ael macro
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top