Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Automatic level control (ALC)

Status
Not open for further replies.
V

vco96

Member level 1
Joined
Mar 16, 2004
Messages
32
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
317
Anybody how to build one using a gual gate fet and a diode detector. Freq rance 0-500 MHz.

I'm thinking to make a tap at the output and feed it to the diode to get a DC voltage, then maybe add an op-amp or two or maybe make a summing amp which should control the gain of the fet.

I'm using BF980 for the fet.

Appreciate any suggestions.
 

This is more general.Because is two gat,used one as a control.

To config the circuit as AGC. You may use the opanp as integer,and control the ibteger coefficient.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top