Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

change the PCB board size in Eagle

Status
Not open for further replies.
vinodquilon

vinodquilon

Full Member level 3
Joined
Oct 24, 2009
Messages
158
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
2,558
How can I change the PCB board size in Eagle .brd file, so that I can construct large boards ?
Is it a proper way to use 'move' tool to adjust corners, thus can increase board size ?
 

Simply, click on the corner or board side, and drag it where you want it.
 

The board area is defined by the 'dimension' layer - 20 I think. Either drag it, as already suggested or delete it & draw it. Be careful to set the grid before drawing it if you want an exact size. For example, if you want a 100x160mm board you don't want the grid set to 0.1".

Keith
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top