Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

need help in ring vco design

Status
Not open for further replies.
S

sekharcvr

Newbie level 3
Joined
Mar 19, 2010
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
hyderabad
Activity points
1,303
hi
iam designing vco in 180nm technology using differential ring oscillator.we have to get sinusoidal output.but we getting costant dc line.our circuit n testbench n output we r getting are attatched below. we r not getting any oscillations.

can any one help me if there are any mistakes in our ciruit. or give 3 stage differential ring oscillator circuit
thank u in advance.
 

Hi,
I am trying to design the same. Attached is a document that shows a differential ring oscillator.

Did you get a simple single ended three stage oscillator running?

Try that first to see if you can get it to oscillate.

It is a simple circuit with three inverters in series and the output of the last inverter connected to the gate of the first.

Make sure you set an initial condition and set an initial voltage with the Nodeset command in Spectre. This is needed to start the oscillations.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top