Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

phase lock loop design using 74hc4046

Status
Not open for further replies.

f1kr1

Newbie level 6
Joined
Nov 22, 2009
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
malaysia
Activity points
1,345
phase lock loop design.

im designing a phase locked loop as a FM demodulator using 74hc4046.
Can anyone explain to me what expected output at the output of phase detector and VCO. The output signal that I get from VCO is exacly the same as the input signal.
but oscilloscope show nothing at the output of the phase detector.
can anyone tell what might be the problem.
 

Re: phase lock loop design.

The output of the phase detector will be D.C (voltage or current).. which is propotional to the phase error between the input and output.. this controls the frequency of VCO.. After sometime the freq of VCO will be equal to the Freq of input signal and hence both are similar and if Phase is equal then phase detector output is zero..
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top