Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

the AD,PD...of BSIM3V3 mosfet in hspice

Status
Not open for further replies.
L

layan

Member level 1
Joined
Nov 13, 2009
Messages
39
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,501
hi every body
i use the hspice model of BSIM3V3 mosfet(0.35 um of AMS).
how can i calculate the area and premeter of drain and source(AS and AD and PD and PS) of this mosfet for using in hspice?

thanks
 

layan said:
how can i calculate the area and premeter of drain and source(AS and AD and PD and PS) of this mosfet for using in hspice?
Click to expand...
If you use a PDK, they will be calculated automatically during netlisting. From a layout, the physical dimensions are extracted to create the appropriate netlists for LVS and postLayout simulation.
 

    L

    layan

    Points: 2
    Helpful Answer Positive Rating
thanks but what is pdk?
 

layan said:
thanks but what is pdk?
Click to expand...
The Physical Design Kit (0.35 um of AMS)!
 

    L

    layan

    Points: 2
    Helpful Answer Positive Rating
yes, but sorry i didnt get the answer of my first question ? :(
i put here the hspice model of this mosfet here
 

layan said:
i put here the hspice model of this mosfet here
Click to expand...
This is publicly available material. What should we do with it?
 

    L

    layan

    Points: 2
    Helpful Answer Positive Rating
What are you using to draw the schematic and create the Spice netlist? Ideally that software would calculate AD PD etc from the design rules.

Keith
 

    L

    layan

    Points: 2
    Helpful Answer Positive Rating
no i m writing the netlist myself
 

Ok. You will have to estimate it yourself. I presume you have the process layout rules? If you have a gds file of primitive devices that can help.

Either way, you need to find out how big the drain width and length need to be for a specific (minimum) size transistor. This could be 2um for a 0.8um process, for example. The other dimension will be the device width plus say 2um. From this you can work out ND, AD, PD etc.

For a first design pass you can omit them and just add them when you have sorted out the basic design.

I could be more specific with examples tomorrow but I am doing this on my mobile phone.

Keith
 

    L

    layan

    Points: 2
    Helpful Answer Positive Rating
PDK=Process Design Kit
when you write netlist you should determine L and W if your model is 0.35um then L=0.35um and W must determine with yourself and your circuit properties.

if you need you can estimate with this equations:
AD = AS = 2.5*Lmin*W
PD = PS = 5*Lmin + W or 5*Lmin
 

    L

    layan

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top