Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need help what measurement needed after fabrication done.

Status
Not open for further replies.
D

derek638

Newbie level 3
Joined
Jan 12, 2010
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
Dear All,

Need some advice and help regarding this matter.
What measurement needed and how to measure the results of the fabricated antenna whether it is working well same as the stimulation result?

thanks for taking time to answer my question.
 

Re: Need help what measurement needed after fabrication done

Hai u should measure the "Return Loss-s11" value using Network Analyzer and it should be -10dB min ( or above than that) in ur operating frequency and check bandwidth. If it is working fine then u go for radiation pattern measurement in a anechoic chamber.
 

Re: Need help what measurement needed after fabrication done

If i m doing Slot antenna design which able to work in 915 Mhz, do u have any suitable design which can provide -10dB min ? My design currently cant provide this output. Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top