blitzkreig
Newbie level 1
Hello everybody.
I wanted to use a 27c256 EPROM as a binary to bcd converter. Basically the 16 bit binar number is the address while a 8 bit bcd in the output. Simple enough. But I don't know how to produce a bin or hex file which would load the wanted data in the EPROM.
Please note that this is a part of a designing project and we are not allowed to use a micro-controller.
Could any of you point me to the right direction? For example, the syntax of the hex file or bin file would be greatly appreciated. Thanks in advance.
P.S. I'm fairly new to the forum, so my apologies if the thread is not in right place.
I wanted to use a 27c256 EPROM as a binary to bcd converter. Basically the 16 bit binar number is the address while a 8 bit bcd in the output. Simple enough. But I don't know how to produce a bin or hex file which would load the wanted data in the EPROM.
Please note that this is a part of a designing project and we are not allowed to use a micro-controller.
Could any of you point me to the right direction? For example, the syntax of the hex file or bin file would be greatly appreciated. Thanks in advance.
P.S. I'm fairly new to the forum, so my apologies if the thread is not in right place.