Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how i can match my diffrential power amplifier with a 50&amp

Status
Not open for further replies.
R

rezaee

Full Member level 2
Joined
Jul 3, 2009
Messages
129
Helped
4
Reputation
8
Reaction score
1
Trophy points
1,298
Activity points
2,117
matching question

how i can match my diffrential power amplifier with a 50Ω output load?
 

matching question

you can add impedance matching network at the ouput.... S parameter simulation might be helpful ....
 

    R

    rezaee

    Points: 2
    Helpful Answer Positive Rating
Re: matching question

thanks, please describe me more about the possible topologies that i can use in the output of diffrential amplifier ??
when i do s-parameter simulation how i can recieve the best impedance matching network?
 

matching question

I used ADS(advanced design system) previously to match 50 ohm impedance. ( I m not sure which simulation tools u r using..)

You can use the termination provided by tools itself to match you input or ouput impedance..... we preferred LC matching network..

you can use smith chart while doing s-parameter to match your ciruitry more precisly.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top