Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

how to test an op amp 741

Status
Not open for further replies.

sukanya

Newbie level 4
Joined
Jan 22, 2004
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
66
ic 741 tester

hello
i am building an IC TESTER which aongst its various functions has to test for proper functioning of op amp 741.How can i test it? i am using PIC for testing of various logic ics as of now.
thank you.
 

how to test an op amp

You could hook the 741 up as a noniverting buffer (connect the output of 741 with the inverting input).
Then you could test if a digital signal feeds through one to one.
But this tells you only if the 741 is totally "dead'.

To verify specifications you will need various 741 set-ups.
 
741 buffer

Another way is to create a multivibrator using 741 and test it.ut this method of testing will force you to use different iC bases for testing each ics The above mentioned voltage follower method is a simple one and good for easy checking
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top