Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

using bmsLib instances in spectre simulation?

Status
Not open for further replies.
O

oermens

Advanced Member level 2
Joined
Nov 19, 2005
Messages
525
Helped
107
Reputation
220
Reaction score
44
Trophy points
1,308
Location
canada
Activity points
3,988
How can I use instances from bmsLib, which have veriloga and verilogams views, in a spectre simulation? I added veriloga and verilogams to the beginning of my switch view list and the circuit netlists without warning/error, but the state of the instance does not change when an input is given. I can't even get an inverter to work. Do i have to use inputs other than those in analogLib?
 

Verilog-A and VerilogAMS are understood by spectre without needing any additional care (no need for special sources or interface elements as you would need for pure verilog cells and mixed-signal simulation).

The inverter cell has a default threshold voltage of 1.5V therefore if you are using 1V logic it won't change.

Added after 1 minutes:

BTW the default delay is also quite long...
 

    O

    oermens

    Points: 2
    Helpful Answer Positive Rating
Thanks. I took a look at the threshold and delays and adjusted them accordingly.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top