Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Op-amp Fundamental Test - what parameters to measure?

Status
Not open for further replies.
C

conanhaha

Junior Member level 2
Joined
Dec 20, 2008
Messages
21
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,486
Op-amp Fundamental Test

Hi all~
I am constructing an IC tester for op-amp now, which require to test most of the fundamental parameter of op-amp and need to make sure that, if the op-amp pass my test, then it should be working fine.
So I construct a simple circuit to test for it's parameter.
Currently I can only able to test Input offset voltage, Input offset current, Input Bias current.
So how to test the other parameter like input impedance, output impedance, CMRR, slew rate, voltage swing or any other parameters?

This is my circuit that can test the offset current/voltage, bias current by varying the Rf, Ri, Rc value.
So what can i add in to test the other parameters and how?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top