Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Multiple net classes in a single net in Eagle Cadsoft

Status
Not open for further replies.

aatschouten

Newbie level 1
Joined
Nov 4, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Netherlands
Activity points
1,288
How can I specify in the schematic different wire widths or net classes for a single net?
The only way I know is to change wire width on the board after it has been routed. The idea behind it is a circuit with a SMPS where the large current power tracks must be wide, but there is no need and also no room on the board to use the same track width for the low current signal lines of the ssame net. When one separates the high- and low-current parts of the power lines in two nets, at the moment the two nets are connected on the schematic a single net class must be chosen.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top