Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to use Differential Port Setting in CST 2009?

Status
Not open for further replies.
U

unclechoy

Newbie level 3
Joined
Jun 25, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,299
I working on a project and it need to feed the signal by using differential port so that the phase shift is out of phase by 180 degree.

It's not the simultaneous excitation method which select in "Excitation Selection" in Transient Solver Parameters.

Anyone can help?
Thanks!
 

Re: How to use Differential Port Setting in CST 2009

*bump

Anyone can help?
 

Re: How to use Differential Port Setting in CST 2009

I have the same problem did you find a solution for it? if you found it please help me.
 

Re: How to use Differential Port Setting in CST 2009

If you do not wish to use the simultaneous excitation feature, then the alternative would be to use 'Combine 3D Results' post-processing template.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top