Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Depends on how the frequency relates to the geometry. Dimensions larger than lambda will give significantly different error from dimensions smaller than lambda. The error will depend on the individual problem I would guess.
I haven't used q3d, but this is the general principle.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
