Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Cantilever Design in MEMS module of Comsol

Status
Not open for further replies.

adim1234

Newbie level 1
Joined
Oct 5, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
Hi,

I have been trying to design the cantilever beam in 3D MEMS module,
but always come an error crops up i.e:

"No convergence achieved.."

Is there a problem with the amount of force I apply at the edge or mesh resolution or something else?

**Also, How do I vary the thickness and observe the respective change in displacement for the same load??

Can somebody help me, by giving a detailed stepwise procedure to design a simple 3D cantilever beam or give a link to a ppt or pdf which will be useful to me..

Thanks.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top