Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What would happen IF I forgot to add the strap? SOS!

Status
Not open for further replies.
V

visualart

Advanced Member level 1
Joined
Dec 21, 2001
Messages
466
Helped
28
Reputation
56
Reaction score
4
Trophy points
1,298
Activity points
3,333
what would happen that I forgot to add the power/ground strap in my project?
the project area 2x2mm,core 1.4x1.4mm, o.13um technology,
Because my carelessness, the last layout mistake the strap, NOW , the masks always were made. what would happen? Can the chip run?
How to retrieval it?

My GOD ! My boss will Kill me!

:):::::::::::::::::::::::::
 

visualart said:
I forgot to add the power/ground strap in my project
Click to expand...
What do you mean? Forgot to connect the sub taps to GND and the well taps to VDD? LVS should have found this!
visualart said:
Can the chip run?
Click to expand...
If so, very probably not, sorry!
visualart said:
How to retrieval it?
Click to expand...
New masks.
visualart said:
My boss will Kill me!
Click to expand...
So better run!
 

lvs would cause problem and won't show smiley face..check the connectivity..very important
 

the straps are used to reduce the IR drop!
with 0.13um technology , hou much voltage will the 1400um length wire bring on ?

I ......
 

visualart said:
with 0.13um technology , hou much voltage will the 1400um length wire bring on ?
Click to expand...
Try Ohm's law ;-)
ΔV = (Ohms/square of used metal) * (number_of_squares) * (medium_current)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top