Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Close circuit television has noise

Status
Not open for further replies.

tong2007

Newbie level 2
Joined
Jul 2, 2008
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
thailand
Activity points
1,292
close circuit

My cameras living near radio broadcasting station,this effect to picture on TV it has many noise on television.Please help me I want to build small project to reduce this noise who has noise protection circuit ? please post to me.
 

First you have to determine where the noise or interference is entering the system. Is it being picked up by the camera? Or is the noise being picked up by the cable between the camera and the monitor or recorder?

The easiest test is to move a monitor very close to the camera using only a short cable to connect them. If the interference is gone or at least minimal, then it is likely that the cable is acting like an antenna and picking up the local radio station. In this case, you will need to use a cable with a better shield or enclose the cable in a shielded conduit. If neither of these work, you may have to modulate the video and send it down the cable as rf, rather than baseband video.

If the interference seems to be coming from the camera, then you have to either build an rf cage around the camera, or get a better shielded camera. Try wrapping the camera body in aluminum foil then grounding the foil. If this reduces the interference, then you need better shielding at the camera.

I think the solution is to reduce the interference before it corrupts the video. Once the signal is corrupted, it is very often difficult to filter out.
 

It’s also possible that the noise passes through power supply ..
Trt to test your camera with a battery (short leads) and see how it performs ..

Rgds,
IanP
 

tong2007 said:
My cameras living near radio broadcasting station,this effect to picture on TV it has many noise on television.Please help me I want to build small project to reduce this noise who has noise protection circuit ? please post to me.
All cables connecting the switcher, camera, and the TV shud be high quality shielded wires with braids grounded, and body of all the equipments should be grounded. Good luck.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top