Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
you can use lc tank (resonating at your rf frequency) between your ports.this can remove the lo to rf capacitors that make the feedthrough between ports.but in the case of single ended mixer it's too difficult to improwe isolation and i'm not sure this method be useful.also you can use cascode transistor between them.
Did you find this post helpful? Click:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.