Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Error Code:997 and USB Error SE: 100 when using BRENNER 9 for DSPIC

Status
Not open for further replies.
N

noob64

Newbie level 4
Joined
Aug 27, 2009
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Romania
Activity points
1,339
brenner 9

Hi , I've recently built the Sprut's Brenner 9L programmer **broken link removed** but the software USBURN throw 2 errors : Error Code:997 , and USB Error SE: 100 (on the programmer window) .The programmer is detected , also my dspic33fj128 but I cannot do more operations (he throw that errors).:?:
I have read the brenner 8 & 9 manual and I've done all that says there about the errors , but no good results. Sometimes i can only do erase or CP removal but 1 at 10 try.
If someone dealt with those errors I will much appreciate some help.
THX.
 

dspic usb

If it is a ICSP type of programmer with a cable connecting the programmer with the target, try to make the cable short (25cm max).

I had an ICSP type programmer who had similar problems and i put som aluminium foil around the ICSP-cable for extra shielding and viola.. worked..
I guess the ICSP-cable was a little bit to long.

Maybee worth a try.

/Mateo
 

usb brenner

I've connected it directly to the ICSP ("cable" aprox 2 cm) , and the same problem , I don't know why this error persist all is done exactly like it says on the site.Next try will be on a laptop.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top