Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

meaning of "full wave" in HFSS, references for FEM

Status
Not open for further replies.
J

johnson.mike

Full Member level 1
Joined
Nov 29, 2007
Messages
96
Helped
8
Reputation
16
Reaction score
6
Trophy points
1,288
Location
Around the world
Activity points
1,766
Question in hfss?

HFSS is a high-performance full-wave electromagnetic(EM) field simulator

Here what is the meaning of "full wave" electromagnetic field simulator?

Any Good reference for FEM and MOM?

Any one have the below one
Analytical and Computational Methods in Electromagnetics by Ramesh Garg
 

Re: Question in hfss?

I'm new to HFSS.
There are three solution type available.
Driven terminal.
Driven model
Eigen Mode
Which one we can use for antenna and board anlaysis applications.?

regards,
johnson
 

Question in hfss?

For the first post, HFSS simulates wave propagation from Maxwell's equations, it makes fewer simplifications than other simpler, faster solvers. I'm not that experienced with either FEM or MOM, but Sadiku's Numerical Techniques in Electromagnetics provides a decent introduction to many of the most common solving algorithms. There are many other books out there especially for FEM, and several other types of books have intros/sections devoted to one or the other, IE Balanis Antenna Theory. Sorry, don't have that book.
 

Re: Question in hfss?

Driven terminal is a good place to start, it is very much like using a source and load like in the lab. When you are able to have driven terminal and driven model results match, then you know how to use driven model. Driven model is more for waveguides and other structures that can be excited in different modes.
 

Re: Question in hfss?

thanks for your reply.
One more question,
How to add s parameter of two different design in to single file.(say results of two microstriplines with two different gaps).
 

Re: Question in hfss?

johnson.mike said:
thanks for your reply.
One more question,
How to add s parameter of two different design in to single file.(say results of two microstriplines with two different gaps).
Click to expand...

hi johnson.mike,
you can export the two series of s parameter and plot them in matlab.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top