Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PIC micro software question

Status
Not open for further replies.
G

gzorzi

Junior Member level 1
Joined
Jul 24, 2002
Messages
15
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
123
I use PBP & Microcode studio plus and are OK If I want write my program in C language which is it the best solution with ICDebug ?
 

hi
there's no ideal compiler, just choose one that you can integrate into MPLAB
i like CCS, easy to use with its amount of built-in device 'drivers'
if you are more hard-core C coder you will prefer Hitech
 

I don't know about CCS but Hi-tech is ANSI compatible, meaning you could port your code to other Micros easily (in theory at least).
 

Hi,

I think that would be CCS c compiler and ICD1 with CCS firmware!


Regards

Hugo


:D :D :D
 

HI,

The comparison between CCS & HiTech compilers

**broken link removed**

Bye
 

More, HI-TECH C compiler can be found for free :wink:
search a little bit...
 

IAR is the professoinal IDE provider for most microcontrollers family. Check in www.iar.com
The IDE is very intuitive and single utilization... go to the page and donwload the evaluation version and verify!!!

gorkin :wink:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top