Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

class d output design or gate driver

Status
Not open for further replies.

gqxfw

Junior Member level 3
Joined
Jul 3, 2002
Messages
30
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
126
I want to design a class d output. who can give me some gate driver design document. Thansk
 

I'll work on this with you - PM me. Basically you need an H-bridge which is pretty simple to make, just some big mosfets (30000/0.5).

If you don't want to worry about break-before-make and all the other driver tricks, you can use an H-bridge driver IC and just feed it a logic signal from your controller.
 

Hi electronrancher

How was your class D design?
Was it a delta sigma modulated or PWM modulated?
Any spec results?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top