Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

SIM508 GSM serial interface

Status
Not open for further replies.

fayek

Newbie level 1
Joined
Aug 16, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
egypt
Activity points
1,289
sim508 interfacing

Hi ALL,

I try to send AT commands using microcontroller to the SIM508 EVB but it don't respond and I find disturbance in the behavior(appear in the status leds).

when I use the pc to simulate the board behavior it work well, also interfacing the board with the PC and sending AT commands work well.

note: in some cases I may notice the disturbance just during connecting the serial cable or connecting the power to the microcontroller board.

I hope some one respond soon.

THANKS
Fayek
 

sim508 evb board

HI

after some investigation, we found that we should pull some signals high, these signals are other than the Tx and Rx even that we don't use flow control
and the problem was solved

Salam
Hossam Alzomor
www()i-g()org
 
Hi Alzomor, I am just starting project with pic and SIM508. Can you post diagram of the connection? may be it will be beneficial not only for me :)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top