Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PWM function using fast comparator

Status
Not open for further replies.
J

jayce3390

Full Member level 6
Joined
May 22, 2007
Messages
351
Helped
29
Reputation
58
Reaction score
21
Trophy points
1,298
Activity points
3,287
pwm function

Hi,

I m trying to generate a PWM signal at the output of the lt1016 comparator.

My idea is to compare a basic sinusoidal signal with a linear ramp signal aids of this comparator.
The linear ramp (called IN-) is plotted in blue.
I don't have idea to set up a correct linear ramp, what is the proper frequency the linear ramp should have?


 

comparator pwm

what is the proper frequency the linear ramp should have
Click to expand...
Completely depends on then intended PWM purpose. Considering, that the post has been placen in RF, Microwave, Antennas and Optics forum, I don't have an idea. If you possibly intend reproduction of sine wave by the PWM, your example obviously indicates a too low PWM frequency. Why don't you simply try empirically?
 

    J

    jayce3390

    Points: 2
    Helpful Answer Positive Rating
pwm using comparator

Thank you.
Empirically? what do you mean?

I posted in "RF, Microwave, Antennas and Optics" because I want to do a fast PWM, i.e >1MHz.

But if a Moderator could move my post in a proper forum I will appreciate.

I need a PWM able to run with a 5 MHz (at the beginning I m using a 1 MHz signal). The comparator used is a very fast comparator, I guess able to follow a 5 MHz input signal...
I m trying to obtain a signal with a varying duty cycle according to the input voltage level.
 

fast ramp function

It sounds like you are not in fact building a PWM circuit, but a one-bit Analog-to-Digital converter. Nyquist says that you will need to sample at at least the "Nyquist Frequency", which is >2X the highest input signal frequency. With this sort of one-bit converter, I would start off at more like 6X the highest input frequency for the ramp repetition rate.
 

    J

    jayce3390

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top