Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Symbol element to simulate patch (ADS2006A)

Status
Not open for further replies.
E

EnricF

Newbie level 6
Joined
May 21, 2009
Messages
14
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,372
Hi,

I want to simulate a single patch in order to find it input impedance (with ADS2006A). But I don't know which symbol is, so I attach a project using transmission line working like a patch antenna.

If this is the correct mode, I have other question. Thinking the air has an impedance near 120*3.1415 would I feed the tx line with a 50 ohms input impedance and a 377 ohms output impedance or must use 50 ohms for both sides?

Could someone help me?

Thanks,
Enric.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top