Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ICD2 Clone rev B, where can I buy industrial PCB ?

Status
Not open for further replies.
B

buddace

Junior Member level 1
Joined
May 6, 2007
Messages
18
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,378
icd2 clone kit

I looking for industrial PCB of ICD2Clone rev B
 

fti232

Where are you located ?

As far as the PCB design is concerned you have it on the very site where you got "ICD2Clone rev B" schematic.

You just have to talk to your PCB vendor to get it done.
 

icd2 + buy used

KiranVSutar said:
Where are you located ?

As far as the PCB design is concerned you have it on the very site where you got "ICD2Clone rev B" schematic.

You just have to talk to your PCB vendor to get it done.
Click to expand...
I'm in Italy....my pcb maker only for two pieces is too expensive
 

jun industrial pcb

I have built the whole of ICD Clone on general purpose PCB and working fine for the last 5 months. It took 1 day to assemble and get it working.

It is ICD, using RS232. But it works fine.

Saved a lot of $$$.
Helped me to develop a whole range of products.
And am quite satisfied.
And now I can purchase the official ICD from microchip....that is with USB connecttivity.
 

I built homemade ICD2 clone 6 months ago..i used for 5 months...but now don't work! PCB was damaged .....
 

I have one.
See picture.

I have PCBs for a JtagIce&Isp, Ulink, USB ARMJtag, AVRProg, ARM dev. board ,.....
 

I would buy a ready made icd2 clone on ebay ... there are very cheap now.
and please choose a usb clone... rs232 is tooooo slow.
 

That web page contains the PDF files for PCB of ICD2Clone.

I had hardtime to bring Pdf file into films. I got the PCBs, using the same PDF File. And just today I started the new ICD2Clone. and it works absolutely fine. previously it was on a General Purpose board.
 

Thanks All, but I looking for ICD2clone rev B or C USB (without rs232 or FTI232)
 

buddace said:
Thanks All, but I looking for ICD2clone rev B or C USB (without rs232 or FTI232)
Click to expand...


Try this.

If it is acceptable, then I can send other files.
 

here is another link:



for ICD2Clone Rev.C
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top