Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Microcontroller Broken - Can't synchronize with the device

Status
Not open for further replies.
C

cipriqe

Newbie level 5
Joined
Jun 2, 2009
Messages
10
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,340
broken pins of microcontroller

I hav a development board with ATmega 128 and i want to program other MCU with it, I put wires on bord to pins MISO MOSI si SCLK (SPI program) and connect with te MCU Atmega16. It works a very short time, i cant write and erase a program a few times. And the MCU is borken or loked , i don't know. I recieve the messafe Can't syncronyze with the device. What is the problem ?
Pls help me
 

Microcontroller Broken

Hai cipriqe
Try connecting a 2 Mhz crystal (Any other crystal below 16 Mhz will do ) to the oscillator pins of the chip bieng programmed and then try. Good luck.
 

    C

    cipriqe

    Points: 2
    Helpful Answer Positive Rating
Re: Microcontroller Broken

i used an 10Meg Hz crystal..
 

Re: Microcontroller Broken

Hai

Most Probably you have messedup with fuse bits, (disabling serial programming)

BTW what programmer are you using for programming

MicroCon
 

    C

    cipriqe

    Points: 2
    Helpful Answer Positive Rating
Re: Microcontroller Broken

i dosem't work to the fuse bits, I just erased and wrote de MCU... It can be the current on this pins ?
 

Microcontroller Broken

Hai cipriqe
Yes..you are correct. 10 Mhz will do the work. If didnt work try any other crystal below that. After connecting the crystal, you have to erase the chip, program it with the default fuses and then the chip is reday for next programming. Good luck.
 

    C

    cipriqe

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top