Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

TEM mode with a waveguide port in CST

Status
Not open for further replies.
D

dpuentegarcia

Newbie level 5
Joined
May 8, 2009
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,330
set port in cst

Hi everyone,

I have a problem. I am simulating a FSS cell in CST Studio and I want to calculate the reflection coefficient in a frequency range with a plane wave (TEM mode). I am using a waveguide, but I am not sure which mode I am exciting with a waveguide. Any of you can you tell me how to excite a TEM mode with a waveguide port.

Thanks in advance,

David
 

tem mode in waveguide

Hi,

You should set a waveguide simulator with two opposite magnetic walls parallel to the electric field and the other two walls as electric walls. Then, put waveguide ports where you want the plane wave to incide.

Regards,

Iaia
 

Hi,

I not sure, what is FSS cell, but so you have TEM mode, you probably use coax waveguide as source. In set of port you can set number of mode, the TE or TEM will be set automaticly. For exemple, for rectangular waveguide the port will in TE mode automaticly, you can set number of mode.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top