Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Spectre: How to restart tran. simulation?

Status
Not open for further replies.
C

chippendale

Member level 1
Joined
Dec 14, 2007
Messages
34
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,522
Hi guys,
I use spectre in IC5141. I want to extratct the operation point at an exact point of a schematic. After this I want to restart the simulation from this point on. Do you have some experience how to manage this?
By the way, is there a solution to change temperature in a tran. simulation?
Thx.
 

you could simulate the all process,after that you print the transient operating points. A dialog box would appear and then you type the time you want.
 

The problem is vice versa. The decision to restart the transient simulation depends on the operation points. So how can I restart the simulation when the ops are not those which they should be.
 

chippendale said:
Hi guys,
I use spectre in IC5141. I want to extratct the operation point at an exact point of a schematic. After this I want to restart the simulation from this point on. Do you have some experience how to manage this?
By the way, is there a solution to change temperature in a tran. simulation?
Thx.
Click to expand...

Hi,
 

Yes you can do that., for example
tran tran stop=0.5u param=temp param_vec=[0ns -40 50ns 110]
You can include the last part in the additional parameters tab in the tranisent sim options.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top