Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Test equipment for PA, mixer, synthesizer?

Status
Not open for further replies.
W

winglj

Full Member level 4
Joined
Feb 21, 2005
Messages
195
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
3,063
pa mixer test

Hi, everyone. I have a simple question about the test equipments required for testing the RF power amplifier, mixer and frequency synthesizer.

1. For RF power amplifier, in order to test its P1dB, Saturation power, and output IP3, besides the vector network analyzer, what are other equipments needed?

2. For the mixer, how to characterize its conversion loss and noise figure?

3. For frequency synthesizer, beside the spectrum analyzer, what other equipments are needed to test it?

Thanks.
 

1. Power Meter (peak, average, RMS, etc), Two RF Signal Generators with multiple modulations, Spectrum Analyzer, Load Pull Tuners, Power Supply with accurate current and voltage readings.
2. Network Analyzer, Two RF signal Generators, Spectrum Analyzer with NF measurement option.
3. Spectrum Analyzer with Phase Noise measurement option, Modulation Domain Analyzer for settling time measurements, Frequency meter.
 

    W

    winglj

    Points: 2
    Helpful Answer Positive Rating
vfone said:
1. Power Meter (peak, average, RMS, etc), Two RF Signal Generators with multiple modulations, Spectrum Analyzer, Load Pull Tuners, Power Supply with accurate current and voltage readings.
2. Network Analyzer, Two RF signal Generators, Spectrum Analyzer with NF measurement option.
3. Spectrum Analyzer with Phase Noise measurement option, Modulation Domain Analyzer for settling time measurements, Frequency meter.
Click to expand...

I think for PA, based on your request: P1dB, Psat testing. Besides 3 Power Meters (peak, average, RMS, etc), Two RF Signal Generators with multiple modulations, Spectrum Analyzer, you only need attuators, two couplers. also maybe you need a driver as well as the DC supplers.
 

    W

    winglj

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top