Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help with Triac Control for up to 50mA Gate Trigger Current using TXC10M60

Status
Not open for further replies.
R

ramanh

Newbie level 3
Joined
May 6, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,300
Hi there is it possible that someone can help me with the above Phase control IC.I'm encountering some problems with the Application example - Triac Control for up to 50mA Gate Trigger Current.I've reduce the AC voltage to 26V AC too suit my circuitry,which drives a 24V 150W halogen lamp.With this I changed some resistors for eg Rsync is 27K and the input resistor is 390 ohm and also changed the TXC10M60 with a common used TIC225M triac.

No luck with the circuit.Help please
 

txc10 m60

change the capacitor value,increase that value of 10th and 12th pin capacitor.if u change input voltage means u have to change the design,so give 230 v AC,,as per the circuit,,,check the ground properly,otherwise shorted,,,,,,,,


try u will suceed
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top