Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

dual band dipole with pass band filter in HFSS

Status
Not open for further replies.

lostmymind

Newbie level 6
Joined
Mar 31, 2009
Messages
11
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,353
dual band filter

Hi All,

I am currently trying to design a dual-band dipole in HFSS. The idea is to create the two resonant frequencies by inserting a filter at some point of the dipole cylindrical arm which allows the signal to pass at the lower frequency and does not at the higher resonant frequency.

The thing is I don't know how to insert such a filter in HFSS. I first tried to use Lumped RLC by creating an extra cylinder and assigning it this type of boundary condtion. But it appears that this only simulates a parrallel R,L,C circuit, thus synthetizing a filter cannot be done with Lumped R,L,C.

Does anybody have a clue on how to proceed?

Thanks.
 

di pole filter

hi
i need a dual band dipole antenna design. I am new on hfss . can you help me please

thanks
 

dual-band+filter

Hi hasanynlmz,

For your dual band dipole you could choose to design a dipole with a trap.
You can find a lot of informations about trap antennae with a quick search.

But basically it is a LC resonator tuned at the higher frequency of the two of interest, and it allows the current to flow at your lower frequency whereas at your higher frequency it acts as a very high impedance. So with just a single fed dipole you can have a dual band antenna thanks to the trap.

In HFSS in order to model the LC circuit you need to use the RLC lumped in Assign Boundary once you've created your structure for the trap (generally a cylinder in pec)


Hope this would help

Good luck!
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top