s3034585
Full Member level 4
msp430 +adc
i am using an NTC thermistor and MSP430 to measure temperature between 0 to 50deg C.
ADC10 in msp is programmed to take 32 readings. each time adc10 finishes takings its reading. the first 1-2 readings are quite away from the rest of readings. eventually the readings are stable with a couple of counts different.
has anybody faced same issue.
Also can some please commment on what is the best technique to average these readings.
i am using an NTC thermistor and MSP430 to measure temperature between 0 to 50deg C.
ADC10 in msp is programmed to take 32 readings. each time adc10 finishes takings its reading. the first 1-2 readings are quite away from the rest of readings. eventually the readings are stable with a couple of counts different.
has anybody faced same issue.
Also can some please commment on what is the best technique to average these readings.