Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to simulate switch-capacitor circuits-ac analysis

Status
Not open for further replies.
J

jiawenyin

Newbie level 2
Joined
Apr 19, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,296
I dont's know How to simulate switch-capacitor using ac analysis with spectre.
such as , fully differential opamp with switch-capacitor CMFB. Can you give me
some suggestions.
Thank you.
 

There are few possible ways.
The easiest way is to run the transient analysis long enough for the CMFB to settle. It might take 4-5 clock cycles. Now perform AC analysis. In the AC analysis goto options and click "prevoppoint" to yes. This will start the AC analysis taking the operating point at the end of transient analysis.
 

Don't forget to go to design->environment and write in the analysis order the ac analysis after tran: e.g. Analysis Order: dc tran ac
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top