Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MC34063a Step-Up Converter issue

Status
Not open for further replies.
T

tanky321

Member level 1
Joined
Jan 2, 2008
Messages
32
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,546
mc34063a

Hi,

Im trying to go from 12V to 15V but I seem to be having an issue. I have the inverting setup giving me -15V and it works fine, but I cant get the +15V to work. In this data sheet

https://focus.ti.com/lit/ds/symlink/mc34063a.pdf

on page 6 there is the circuit im using. I dont know about the value of the resistor connected to pin 8, so I used a 220Ω. My values that I calculated are listed below.

L=25uH
Diode= Schottkey Vf=0.5V
Rsense=100mΩ R1=1k pot R2=10k
CT=300pF Co=5uF


Any ideas?


Thanks!
 

mc34063a design tool

Try this online design tool
**broken link removed**
 

mc34063a stepup

I tried it, i get pretty much the same values, so it didnt help me too much.

Anything else?
 

Re: mc34063a stepup

tanky321 said:
I tried it, i get pretty much the same values, so it didnt help me too much.

Anything else?
Click to expand...
output diode shouldn't be inversed to obtain +15V? just my 2 cents, after seeing the schematic for 2 sec.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top