Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HFSS Sweeping Equation Based Curve Helical Spherical Antenna

Status
Not open for further replies.
P

pappaloo

Newbie level 3
Joined
Mar 31, 2009
Messages
3
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,307
hfss sweep along path

I am new to Ansoft HFSS and I have the need to design and simulate a helical spherical wire antenna.

Basically, I have used the equation based curve function in HFSS v11. I now have an equation based curve which correctly models my antenna. Now I am stuck on trying to extract this equation based curve into a wire so that I can assign a material to it. Basically, I have tried to use the Sweeping along a Path with a circle and various other objects with no luck.

Does anyone have any clue how to do this? I can provide the equations/file if need be.

Any help would be greatly appreciated.
 

spherical antenna

It will be good if you can share file with us. so that we can show you how to do it.
Since you have drawn a curve & circle already,
just tell us how you are trying to sweep?
Select circle & curve.
right click--> sweep-->along path (Natural)
is this how you did ?
 
sweep along pathhfss -ieee

Yeah, this is how I tried it. I have posted the file although it doesn't have a circle in it, because I am not sure if that is the correct method to perform.

When I tried to use circle and sweep along path, it gives me error and deletes both objects.

I really have no clue how to do this. Any help is greatly appreciated.
 
  • Like
Reactions: ishtar

    I

    ishtar

    Points: 2
    Helpful Answer Positive Rating
equation based curve

You have drawn a sphere not circle!!!!!!!!!!!!!!!!!!!
Check file I have attached.
The spiral is created.
you just need to delete sphere & make circle at one corner (XZ plane)
& sweep
:D
Abhishekabs
 
hfss spherical

Hi,

Thanks for your help.

No the sphere is the dielectric for the antenna. I had deleted the circle in the first file I sent you.

If possible could you upload a file showing my how to complete this action? I need a the wire to be 0.5mm in diameter for instance.

Thank you.

Added after 5 minutes:

O wait. Never mind. I did not see the file you uploaded.

Thanks for you help!!!!!!

I see exactly how you did it now. I wasn't lining up the beginning of the circle with the endpoint of the antenna.

Again, thanks for your help.
 
Re: HFSS Sweeping Equation Based Curve Helical Spherical Ant

Hi Abhishek

I saw your message regarding " How to draw equation based curve in HFSS " . And I need the same help. But I am not able to open the link which you have posted. If possible can you mail me ? my e-mail id is shekhar.iisc@gmail.com
 
HFSS drawing line curve

i have try to calculate,,but no line have show...
any there example..??
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top