suresh_ecer
Newbie level 5
Dear all,
I m traying to debug LPC2124 in proteus using uVision3 IDE.
I m getting error "Failed to connect TCP/IP port 172.1.1.1:8000"
"GLE:xxxx"
Please advice me what is the possible solution for this.
I have install uvision 3 and Proteus on one machine, is it correct? or i need two machine. One for uVision3 and other for proteus then connnect both through TCP/IP.
Thanks in advance.
Regards,
Suresh
I m traying to debug LPC2124 in proteus using uVision3 IDE.
I m getting error "Failed to connect TCP/IP port 172.1.1.1:8000"
"GLE:xxxx"
Please advice me what is the possible solution for this.
I have install uvision 3 and Proteus on one machine, is it correct? or i need two machine. One for uVision3 and other for proteus then connnect both through TCP/IP.
Thanks in advance.
Regards,
Suresh